417-862-4455
Dana 60 Cross Pin Retaining Lock Bolt GM Ford Dodge Semi-Float Shaft
$3.50
- SKU: 40131-1
- Brand: Dana/Spicer
- Weight: .30
- Shipping: Calculated at checkout
6 in stock
This is a genuine Dana/Spicer bolt that locks the cross shaft into the differential. These were used on many Dana 60 applications. Please note that most Dana 60’s use a roll pin.
| Weight | .30 lbs |
|---|---|
| Dimensions | 2 × 1 × 1 in |
General Inquiries
There are no inquiries yet.
Related products
Small Parts & Seals
271 & 273 Dodge Transfer Case Large Booted Rear Seal 271D 273D 2003+
This is the large booted seal for the rear of a 271 or 273 Dodge transfer case with a rear slip yoke. The New Venture part number is 38249. These are almost impossible to get at your local auto parts store. These are used with the 45379 rear bushing. This seal can also be used [...]
View Details
Small Parts & Seals
Ford Straight Front Axle Tube Dust Seal 1998.5-2005 Dana 50 & 60
This genuine Dana axle tube dust seal fits 1998.5-2005 Ford F250 and F350 dana 50 and 60 straight front axles. This seal is marked FORSHEDA 11 10.060 D768-11 50381.These are approx. 3.125″ outside diameter, which is smaller than the later ones. This seal goes on the axle itself right behind the u-joint at the end [...]
View Details
Small Parts & Seals
Ford Straight Front Axle Steering Knuckle Seal 1998.5-2005 Dana 50 & 60
This is a genuine Dana front steering knuckle seal that fits 1998.5-2005 Ford F250 & F350 with either a Dana 50 or Dana 60 straight front axle. The seal is marked FRESHEDA 5H-15052 A085824 RDS 81. This seal measures approx. 4.46″ outside diameter
View Details
Small Parts & Seals
Ford Straight Front Axle Steering Knuckle Seal 2006+ Dana 50 & 60
This is a genuine Dana front steering knuckle seal that fits 2006 and newer Ford F250 & F350 with either a Dana 50 or Dana 60 straight front axle. The seal is marked SKF 2017426 DANA. This seal measures approx. 5.48″ outside diameter. The original part number was 2017426.
View Details
This is a genuine AAM rear hub snap ring that holds the outer bearing in the hub on a full floating 2011 or newer GM 10.5 or 11.5 rear axle. This snap ring measures 3 7/8″ O.D.
View Details
Small Parts & Seals
GM 7.5/7.6 Rear Axle C-Clip S10 Camaro Chevrolet 10 Bolt 7 1/2″
This is a genuine AAM c-clip for the GM 7.5/7.6 rear axle found in S10’s, Malibu’s, Camaro’s etc. These are copper colored steel. These are for both open and limited slip style carriers. 2 required per vehicle.
View Details
Small Parts & Seals
This is a genuine AAM pinion nut washer found on GM & Dodge 3/4 and 1 ton trucks. This is to be used with nut part number 40003027.
View Details
Small Parts & Seals
This genuine Dana pinion nut washer that fits all Dana 80 rear ends. This goes with the 37082 nut.
View Details