fbpx

Showing 161–176 of 432 results

$27.50

This is a genuine AAM pinion seal for the 10.5″ 4X4 front axle found in 2019+ Dodge Ram 4500 and 5500 series trucks. This differential has a 13 bolt cover. The original Ram part number for this seal is 68456990AA.

View Details
$395.00

This is a genuine AAM left front axle assembly for 2019 and newer Dodge Ram 4500 and 5500 series trucks. 40215225 RAM RAM 4500/500 (DP) 2019+ 10.5″ 13 Bolt – Front Axle L 35 / 33 775.77 RAM 10.5″ FRONT LH AXLE SHAFT ASM

View Details
$395.00

This is a genuine AAM right front axle assembly for 2019 and newer Dodge Ram 4500 and 5500 series trucks. 40215226 RAM RAM 4500/500 (DP) 2019+ 10.5″ 13 Bolt – Front Axle R 35 / 33 768.74 RAM 10.5″ FRONT RH AXLE SHAFT ASM

View Details
$27.50

This is a genuine AAM axle tube seal for the 10.5″ 4X4 front axle found in 2019+ Dodge Ram 4500 and 5500 series trucks. This differential has a 13 bolt cover. The original Ram part number for this seal is 68456977AA.

View Details
$425.00

This a genuine AAM ring and pinion in a 3:42 ratio for the 11.5 rear axle found in some 2019+ GM 2500 and 3500 series trucks. This set includes a crush sleeve, seal, nut, and pinion shim.

View Details
$195.00

This is a genuine AAM pinion flange yoke, for the 12.0 rear axle found in many 2019 and newer GM 3500 trucks.

View Details
$185.00

This is a genuine AAM bearing kit for the 12.0 rear differential found in some 2019 and newer GM 3500 series trucks. This kit includes both pinion bearings and races, both differential side bearings and races, a pinion seal, crush sleeve, and a pinion nut. The inner pinion bearing is a TRA121304-1. The outer bearing [...]

View Details
$450.00

This is a genuine AAM ring and pinion in a 4:10 ratio, for the 11.5 rear axle found in many 2019 and newer GM and Dodge Ram 3500 series trucks. This kit includes a pinion seal, crush sleeve, nut, and washer.

View Details
$75.00

New 246 261 263 Transfer Case Slip Yoke 1344/3R U-Joint Part # 40032054 1344/3R U-Joint 1.88583″ O.D. 7.87402″ Long 32 Spline 1.37402″ Diameter This is a genuine AAM part. OEM Numbers and Replacement Numbers N3R-3-1642X, 40012495, N3R-3-9161X, GM 12479383, 88963576, 7838665, 40009290, 40026154

View Details
$75.00

New 261 / 263 XHD Magna Transfer Case Slip Yoke 1480 U-Joint Part # 40110102 Additional Part #’s 40039594, 55-3-01672X, GM89058880, 22918657 C3-3-709-1 1480 U-Joint 2.20079″ O.D. 8.34″ Long 31 Spline 1.61417 Diameter Please be aware that there were 2 different u-joint sizes available for these trucks. A 1410 (1 3/16″ caps) and a 1480 [...]

View Details
$70.00

This is a genuine AAM driveshaft slip yoke for the 261XHD, 263XHD or Magna equivalent transfer case found in GM 2500 and 3500 series 4X4 trucks with the Duramax diesel or 8100 gas engines. The specs are as follows:1410/1415 U-Joint. 2.20079″ O.D. 8.34″ Long 31 Spline 1.61417 Diameter. Please be aware that not all of [...]

View Details
$79.00

This is a genuine AAM slip yoke for 2003 and newer Dodge Ram 2500 and 3500 series 4X4 trucks with either a 271 or 273 transfer case. This is a 34 spline slip yoke and is for the 1415 series universal joint. 

View Details
$69.00

This is a genuine AAM slip yoke that goes in the mddle of the driveshaft at the carrier bearing. This was used on some Dodge Ram 2500 and 3500 series trucks from 2003-2015. 40021324 Chrysler 2 1485 35 Based on 36 (39.3 Dia) 189.00 52.70 Order 40021327 boot & clamp assy if needed

View Details
$45.00

This is a genuine AAM rear pinion yoke for use on the early 1997 and older GM 8.5 10 bolt. This is for the Saginaw 3R series u-joint with the inside snap ring and no tabs on the yoke. This is for use with a National 2043 pinion seal and can be used on 1998 [...]

View Details
$125.00

This is a genuine AAM real axle shaft that shows to fit 2011-2014 GMC Sierra 3500 HD, 2011-2018 Chevrolet Silverado 3500 HD, 2011-2014 Chevrolet Silverado 3500 HD, 2011-2014 GMC Sierra 3500 HD. This axle is 30 spline and 1023 mm or 40.275″ long.

View Details
$125.00

This is a genuine AAM bare open differential carrier assembly that fit the GM 7.6 or 7 5/8″ rear differential with 28 spline axles and 3:23 or numerically higher (3:42, 3:73, etc.). These were used in early 1990’s and newer S10’s and Camaro’s.

View Details