This is a genuine Dana/Spicer coil spring seat for the factory Spicer lockout hubs found on many late 1960’s to late 1970’s GM and Ford trucks. This goes with the 35218 spring. I know the box shows 10, but they are sold individually.
Dana 44 Early 4X4 Front Axle Lockout Hub Conical Coil Spring Seat Cup Washer Original Spicer Lockout Hubs
$4.25
- SKU: 32589
- Brand: Dana/Spicer
- Weight: .20
- Shipping: Calculated at checkout
Weight | .20 lbs |
---|---|
Dimensions | 3 × 3 × 1 in |
Related products
This is a genuine Dana/Spicer 4X4 front spindle that fit’s the following Ford applications: DANA 44 SPINDLE WITH 5 HOLES. FITS MOST FORD 1977 1/2-1979 F250 . DOES NOT FIT 76-77 LARGE EXTERNAL HUB. BEARING JOURNALS – 2.5″ OUTER & 1.625″ INNER. FLANGE DIA- 6.12″ INNER BRG DIA 2.0” // LENGTH 6.25”
View DetailsThis is a spring seat that goes over the spring and bushing in a Dana 60 4X4 front axle with the king pin setup. These were commonly found in GM, Ford, and Dodge applications from the early 1970’s to the early 1990’s.
View DetailsThis is a genuine Dana/Spicer 4X4 front spindle that fits some 1993-1996 Ford F150 and Bronco’s from 1993-1996 w/o ABS. If you are not sure which part number that you need, please email us with your differential tag number and we can tell for sure.
View DetailsAxles & Axle Bearings
GM Ford Dodge Jeep Dana 44 4X4 Front Axle Cog Gear Slug 19 Spline Full Time Drive Flange
This is a genuine Dana/Spice cog or slug use to replace the lockout hubs on trucks with full time four wheel drive. This is 1.271″ 19 splines on the inside and 2.925″ 48 spline on the outside. These were used in many popular 1/2 and 3/4 ton applications.
View DetailsMiscellaneous
Dana 44 Corporate 10 Bolt 4X4 Front Axle Spindle Bolts Studs Steering Knuckle GM Ford Dodge Jeep
This is a genuine Dana/Spicer stud for the steering knuckle to the spindle.This fits Dana 44 and GM corporate 4X4 front axles. These are 3/8″-24 fine thread and the head of the stud is D shaped in order to clear the axle.
View DetailsThis is a complete set of aftermarket spindle nuts and washers for a Dana 60 front axle. It consists of 2 each inner nut with pin, locking washer, and outer nut with the pin. These were commonly found on GM, Ford, and Dodge applications. They were also used on Dana 50 applications in Ford applications. [...]
View DetailsThis is the gasket for the 4 bolt cap that goes over the spring and bushing in a Dana 60 4X4 front axle with the king pin setup. These were commonly found in GM, Ford, and Dodge applications from the early 1970’s to the mid 1990’s.
View DetailsThis is the upper nylon bushing in a Dana 60 4X4 front axle with the king pin setup. These were commonly found in GM, Ford, and Dodge applications from the early 1970’s to mid 1990’s.
View Details