417-862-4455No products in the cart.
$95.00
This is an aftermarket 4X4 spindle for the Dana 50 IFS front axle found in many 1980-1998 Ford F250 trucks. These were also used in some F350 trucks. This is a 5 bolt spindle. The original Dana part number was 708085. This is a bare spindle, with no bearings or seals.
View Details
$95.00
THIS IS AN AFTERMARKET DANA 44 SPINDLE WITH 5 HOLES FOR LARGE BEARING 1/2 TON DISC BRAKES APPLICATIONS. FITS MOST FORD 1976-1979 F150/F100 SERIES PICK UPS & SERVICE 1976-1978 BRONCO. Original Dana part number was 706552X. This is a bare spindle with no bearings or seals.
View Details
$95.00
This is an aftermarket spindle for the Dana 44 or corporate 10 bolt 4X4 front axle in 1/2 and 3/4 ton trucks, Blazers, and Suburban’s from 1977-1991. The Dana part number is 706570X. This is a bare spindle with no bearings or seals.
View Details
$85.00
This is an aftermarket 4X4 spindle for the Dana 60 front axle in 1978-1998 Ford F350 trucks. This is the same as Dana part number 700022 or 10086724. This is a bare spindle with no bearings or seals.
View Details
$40.00
This is a complete set of aftermarket spindle nuts and washers for a Dana 60 front axle. It consists of 2 each inner nut with pin, locking washer, and outer nut with the pin. These were commonly found on GM, Ford, and Dodge applications. They were also used on Dana 50 applications in Ford applications. [...]
View Details
$65.00
This is a pinion yoke for a 1410 series u-joint that fits GM 14 bolt with a 10.5″ ring gear from 1973-1998. Most of these trucks used a 1350 u-joint. This can be used when upgrading the driveshaft. This yoke uses a half round ridge to keep the joint centered in the yoke. This yoke [...]
View Details
Small Parts & Seals
Jeep Wrangler JK 2007-2017 Differential Side Bearing Shim Kit Adjustable Dana 44 Front or Rear Axle
$17.25
This is an aftermarket shim kit for the Dana 44 front or rear axle found in 2007-2017 Jeep JK Wrangler vehicles. This kit takes the place of the factory shim kits (701149X). This kit has 1 fairly thick shim for either side, and an assortment of thinner shims to go with them.
View Details
$40.00
This is a complete set of aftermarket spindle nuts and washers for a Dana 44 4X4 front axle. It consists of 2 each inner nut with pin, locking washer, and outer nut with the pin. These were commonly found on GM, Dodge, and Jeep applications. They were used on Dana 44 applications in Ford applications. [...]
View Details