417-862-4455
Aftermarket Dana 60 4X4 Front Spindle Ford F350 1978-1998
$85.00
- SKU: 700022B
- Brand: RAJ International Trading
- Weight: 10.0
- Shipping: Calculated at checkout
3 in stock
This is an aftermarket 4X4 spindle for the Dana 60 front axle in 1978-1998 Ford F350 trucks. This is the same as Dana part number 700022 or 10086724. This is a bare spindle with no bearings or seals.
| Weight | 10.0 lbs |
|---|---|
| Dimensions | 6 × 6 × 10 in |
General Inquiries
There are no inquiries yet.
Related products
Axles & Axle Bearings
Spindle Nut Washer Rear Hub Dana 60 Spicer Dodge Jeep Ford Lock
This is a genuine Dana/Spicer spindle nut lock washer with folding tabs. These were used in the 1960’s and 1970’s on many common Dana applications, including Dana 60 and 70 front or rear axles. The I.D. is 1 13/16″. The O.D. is 2.375″ and they are 1/16″ thick. These are the same as Dorman part [...]
View Details
This is a genuine Dana/Spicer 4X4 front spindle for the Dana 60 front axle found in 1980’s and early 1990’s GM and Dodge trucks. This kit includes inner spindle bearing, thrust washer, and the 2 rubber seals for the backside of the spindle. Photo shows spindle bearing installed, but they usually aren’t.
View Details
This is a genuine Dana/Spicer 4X4 front spindle for Ford F350 trucks from 1978-1997 with the Dana 60 front axle. This kit includes the inner spindle bearing, thrust washer, and 2 rubber seals for the back side of the spindle.
View Details
Small Parts & Seals
DANA 44 SPINDLE BEARING & SEAL KIT BRONCO F150 1993-1996 FORD 4X4 FRONT AXLE
Dana 44 IFS BRONCO AND F150 1993-1996 Spindle Bearing and Seal Kit Includes 1 each Spindle Bearing (550759 or SCE2110) and V Seal, Wiper Seal (50492), and Thrust Washer (45651) as pictured.
View Details
This is an aftermarket spindle that fits Ford F150 and Bronco 4X4 front applications from 1980-1992. This is for the Dana 44 front axle. Dana has discontinued this part number.
View Details
Axles & Axle Bearings
GM Ford Dodge Jeep Dana 44 4X4 Front Axle Cog Gear Slug 19 Spline Full Time Drive Flange
This is a genuine Dana/Spice cog or slug use to replace the lockout hubs on trucks with full time four wheel drive. This is 1.271″ 19 splines on the inside and 2.925″ 48 spline on the outside. These were used in many popular 1/2 and 3/4 ton applications.
View Details
This is a spring seat that goes over the spring and bushing in a Dana 60 4X4 front axle with the king pin setup. These were commonly found in GM, Ford, and Dodge applications from the early 1970’s to the early 1990’s.
View Details
This is a complete set of aftermarket spindle nuts and washers for a Dana 60 front axle. It consists of 2 each inner nut with pin, locking washer, and outer nut with the pin. These were commonly found on GM, Ford, and Dodge applications. They were also used on Dana 50 applications in Ford applications. [...]
View Details