417-862-4455
Dana Spicer Hub Nut 6 Point GM Ford Dodge 2″ 16TPI 60 70 Axle Front Rear
$8.50
- SKU: 35270
- Brand: Dana/Spicer
- Weight: .30
- Shipping: Calculated at checkout
This is a genuine Dana/Spicer hub nut. This fits many Dana 60 and 70 axles. It is 2″ inside diameter with 16 threads per inch. This is the same as Dorman 615-127. This uses a 2 1/2″ socket.
| Weight | .30 lbs |
|---|---|
| Dimensions | 3 × 3 × 1 in |
General Inquiries
There are no inquiries yet.
Related products
This is a complete set of aftermarket spindle nuts and washers for a Dana 60 front axle. It consists of 2 each inner nut with pin, locking washer, and outer nut with the pin. These were commonly found on GM, Ford, and Dodge applications. They were also used on Dana 50 applications in Ford applications. [...]
View Details
This is a genuine Dana/Spicer inner spindle nut with the pin that fits many common 4X4 applications including 1/2 ton GM trucks and SUV’s from the mid 1960’s to the early 1990’s. Also some Ford, Dodge, International, and Jeep applications. These are 1 5/8″ and 16 threads per inch.
View Details
Miscellaneous
Dana 44 Corporate 10 Bolt 4X4 Front Axle Spindle Bolts Studs Steering Knuckle GM Ford Dodge Jeep
This is a genuine Dana/Spicer stud for the steering knuckle to the spindle.This fits Dana 44 and GM corporate 4X4 front axles. These are 3/8″-24 fine thread and the head of the stud is D shaped in order to clear the axle.
View Details
This is a master king pin kit for the Dana 60 front ends from the early 1970’s to the mid 1990’s. These fit most domestic applicarions. Included parts are as follows: 2 706395X (lower kit) 2 620132 (Upper 4 bolt cap) 2 37307 (upper 4 bolt gasket) 2 620180 (upper spring seat) 2 41886 (upper [...]
View Details
This is a genuine Dana/Spicer 4X4 spindle for the Dana 60 front axle in 1978-1998 Ford F350 trucks. This is the same as 700022, but is much cheaper. This includes the inner bearing, 2 dust seals, and axle thrust washer.
View Details
This is a lower king pin bearing and seal kit for a Dana 60 4X4 front axle with the king pin setup. These were commonly found in GM, Ford, and Dodge applications from the early 1970’s to the mid 1990’s. This kit does one side. 2 kits required per truck.
View Details
This is a genuine Dana Spicer spindle for the Dana 44 4X4 front axle in 1/2 and 3/4 ton trucks, Blazers, and Suburbans from 1973-1976. This also comes with the dust seals, inner bearing, and plastic thrust washer.
View Details
This is a genuine Dana/Spicer 4X4 front spindle for Ford F350 trucks from 1978-1997 with the Dana 60 front axle. This kit includes the inner spindle bearing, thrust washer, and 2 rubber seals for the back side of the spindle.
View Details