This is a clutch pack for the factory limited slip differential in an 8.8 rear axle. These were common in Ford F150 trucks, as well as Mustangs and Explorers. It is not unusual to have extra clutches in this kit, you may have some left over.
Ford 8.8 Clutch Pack Limited Slip Trac Lock Differential F150 Mustang 28 or 31 Spline
$85.00
- SKU: F8.8CPK
- Brand: Motive Gear
- Weight: 3.0
- Shipping: Calculated at checkout
Out of stock
Weight | 3.0 lbs |
---|---|
Dimensions | 6 × 6 × 6 in |
Related products
Small Parts & Seals
Dodge Dana 44 & 60 Front Outer Stub Axle Castle Nut Also AAM 9.25 Spindle 4X4
This genuine Dana axle nut fits all Dodge front axles including Dana 44 & 60 and the AAM 9.25 found in 2003+ trucks. This is a castle nut. We also have the washer available. This is the same part as AAM 40010627.
View DetailsSmall Parts & Seals
Ford Straight 4X4 Front Axle Tube Dust Seal 2006+ Dana 50 & 60 F250 F350
This genuine Dana axle tube dust seal fits 2006 and newer Ford F250 and F350 dana 50 and 60 straight front axles. This seal is marked FES 5M-15197 and 53877. These are approx. 3.450″ outside diameter, which is larger than the earlier ones. This seal goes on the axle itself right behind the u-joint at [...]
View DetailsSmall Parts & Seals
This is a genuine AAM pinion nut washer found on GM & Dodge 3/4 and 1 ton trucks. This is to be used with nut part number 40003027.
View DetailsThis is a genuine AAM pinion nut that fits the 11.5 rear differential found in 3/4 and 1 ton GM & Dodge trucks. We also have the washer (40003255) available for this nut. This nut also fits the 10.5 Dodge rear differential. We use a 1 7/16″ 12 point socket on these, but it may [...]
View DetailsSmall Parts & Seals
GM 7.5/7.6 Rear Axle C-Clip S10 Camaro Chevrolet 10 Bolt 7 1/2″
This is a genuine AAM c-clip for the GM 7.5/7.6 rear axle found in S10’s, Malibu’s, Camaro’s etc. These are copper colored steel. These are for both open and limited slip style carriers. 2 required per vehicle.
View DetailsSmall Parts & Seals
This is the outer axle nut washer that goes with the 46085 axle nut on 4X4 Dodge front axles, this fits Dana 44 and 60 as well as the AAM 9.25 front axle found in 2003 and newer Dodge Ram 2500 and 3500 series trucks.
View DetailsSmall Parts & Seals
This is a genuine Dana pinion nut that fits all Dana 80 rear differentials. This nut uses an 1 7/8″ socket to remove and install it. Some yokes require a very thin wall socket. The newest Dana part number for this yoke is 2001855.
View DetailsSmall Parts & Seals
This is a genuine AAM rear pinion seal that fits 1998 and newer GM trucks and 2003 and newer Dodge trucks with either the 10.5 or 11.5 rear end. This is for the yoke with the factory wear sleeve on it
View Details