417-862-4455
Outer Spindle Nut Ford Ranger 4X4 Front Axle 1990-1997 Dana 28 1993-1997 Dana 35
$11.00
- SKU: 43749
- Brand: Dana/Spicer
- Weight: .30
- Shipping: Calculated at checkout
6 in stock
This is a genuine Dana/Spicer outer spindle nut for 1990-1997 Ford Rangers with either a Dana 28 or Dana 35 front axle. This is for trucks with manual locking hubs. These are 1.625-16 TPI.
| Weight | .30 lbs |
|---|---|
| Dimensions | 2 × 2 × 1 in |
General Inquiries
There are no inquiries yet.
Related products
Axles & Axle Bearings
Spindle Nut Washer Rear Hub Dana 60 Spicer Dodge Jeep Ford Lock
This is a genuine Dana/Spicer spindle nut lock washer with folding tabs. These were used in the 1960’s and 1970’s on many common Dana applications, including Dana 60 and 70 front or rear axles. The I.D. is 1 13/16″. The O.D. is 2.375″ and they are 1/16″ thick. These are the same as Dorman part [...]
View Details
Axles & Axle Bearings
GM Ford Dodge Jeep Dana 44 4X4 Front Axle Cog Gear Slug 19 Spline Full Time Drive Flange
This is a genuine Dana/Spice cog or slug use to replace the lockout hubs on trucks with full time four wheel drive. This is 1.271″ 19 splines on the inside and 2.925″ 48 spline on the outside. These were used in many popular 1/2 and 3/4 ton applications.
View Details
This is a complete set of aftermarket spindle nuts and washers for a Dana 60 front axle. It consists of 2 each inner nut with pin, locking washer, and outer nut with the pin. These were commonly found on GM, Ford, and Dodge applications. They were also used on Dana 50 applications in Ford applications. [...]
View Details
This is a genuine Dana/Spicer 4X4 spindle for the Dana 60 front axle in 1978-1998 Ford F350 trucks. This is the same as 700022, but is much cheaper. This includes the inner bearing, 2 dust seals, and axle thrust washer.
View Details
This is the gasket for the 4 bolt cap that goes over the spring and bushing in a Dana 60 4X4 front axle with the king pin setup. These were commonly found in GM, Ford, and Dodge applications from the early 1970’s to the mid 1990’s.
View Details
This is a genuine Dana/Spicer inner spindle nut with the pin that fits many common 4X4 applications including 1/2 ton GM trucks and SUV’s from the mid 1960’s to the early 1990’s. Also some Ford, Dodge, International, and Jeep applications. These are 1 5/8″ and 16 threads per inch.
View Details
This is a lower king pin bearing and seal kit for a Dana 60 4X4 front axle with the king pin setup. These were commonly found in GM, Ford, and Dodge applications from the early 1970’s to the mid 1990’s. This kit does one side. 2 kits required per truck.
View Details
This is a genuine Dana/Spicer 4X4 front spindle that fits 1977-1991 GM K30 1 ton trucks and 1975-1998 Dodge Ram 2500 and 3500 series trucks with the Dana 60 front axle. This is the same as part number 700013, but is much cheaper. This comes with the inner bearing, 2 dust seals, and the axle [...]
View Details